Plastic ceiling higher quality than the simple whiting and ceiling wallpaper. Dopuskayutuhod's surface: – the dust can be removed with a soft brush or vacuum cleaner with soft nozzle – plastic ceiling is quite normal to react washing, using a damp sponge, mild soap and warm water. Plastic ceilings are square or rectangular panels of polystyrene foam. The front surface can be covered with foil or painted. On tile surface topography is often created that simulates the stucco or wood carving. No restrictions on use. Recommended for ceilings in homes: rooms, offices, bedrooms, corridors and so forth to the kitchen recommended to use the tiles with a protective coating.
Ceiling tiles glued to almost any surface, pre-prepared. Perfect hide surface defects. If anyone remembers pasting ceilings wallpaper, tile stickers the process of something similar. Especially in the preparation of the surface. The surface should first be cleaned of dust, old wallpaper, old zamyta whitewash. It is desirable to prime the surface of the color next tile. If you make a mistake, and the tiles will fall is not quite exactly, will have the presence of small cracks, priming will not give them sharply manifest.
Applied Adhesives – from PVA glue to the universal. Better, of course, special adhesives for ceiling coverings, higher quality, less problems. Although it is applicable, and other types of adhesives, until liquid nails. Two methods tile from the center and the edge. Each has its own characteristics and disadvantages. Laying of tsentra.Ukladku start producing from the center of the room. Between opposite corners diagonally to pull strings and mark the center at the intersection. Through a designated center thus spend crosswise two straight lines parallel to the walls and divide the room into four equal parts. Produce a pasting. In this method visually for each side of your room there will be cut into smaller ceiling tiles. It is not always a spectacular display. Laying on the edge. Laying begins on the walls of the visual from the entrance, leaving all the flaws and trim tiles less visible on the side of the entrance. From one corner of the room held two lines at an angle to each other at 90 degrees at a distance from the wall 2-3 cm That you provide a geometric fit tiles, eliminate the probable error due to irregularities of the walls. Subsequently, a space perfectly locked and decorated ceiling shaped profiles. Overall in the installation of the tiles glued plitki.Na on the edge of a cover layer of glue. Give him 1-2 minutes to dry. Glue the tiles, pressed tightly to the ceiling. The following tiles stick in parallel rows. Set the profile shapes (ceiling moldings and baseboards) in the color of the tiles, decorative rosettes. An indispensable tool for decorating, and closing of small flaws in tile walls.